3/24/2023 0 Comments J2k viewer free download![]() multiple (batch) JPEG2000 processing to increase general GPU occupancy.Tier-1 and Tier-2 could be done in parallel: Tier-1 on GPU and multithreaded Tier-2 on CPU at the same time (this is also possible at single image mode).both upload to GPU and download from GPU could overlap with JPEG2000 processing on GPU (CUDA Streams).For more complicated workflow it could be better to utilize single image mode, though fps will be reduced.īriefly, JPEG2000 batch mode can take into account specific methods of task parallelism, based on the following: Batch mode is a must for streaming applications when the pipeline contains J2K encoder or decoder. Important limitation for simultaneous processing of several images is imposed by amount of free GPU memory. Moreover, GPU can process several images simultaneously to increase frame rate even more, if each image is too small to load a multitude of GPU cores (especially at Tier-1 stage). It is possible, because we actually have three devices (CPU, GPU and bus interface between them), which can be used simultaneously in that mode, whereas at single image mode these devices are used sequentially for different stages of JPEG2000 algorithm. Some JPEG2000 codecs are optimized for this use case, meaning that exploiting of task parallelism leads to better frame rate (throughput) at the expense of increased processing time for separate images. It is calculated via division of the total time of processing by the number of processed images. In that case frame rate becomes more important than latency. Batch mode consists in processing of batch of images and could be called "throughput-oriented" or "maximum performance". You can get more info from our Image & Video Processing SDK.Ģ. We need single image mode almost in all camera applications. Overlapping of current image processing with other activities is undesirable because it would increase total latency. ![]() It means that software cannot expect that any additional images will be processed at the same time and therefore cannot take advantage of multiple image encoding or decoding. In that case the time interval (latency) between availability of original image in RAM and availability of the processed image in RAM is measured. ![]() Single image mode consists in processing of single image and could be called "latency-oriented" or "low latency" approach. They correspond to the two most common use cases for J2K encoders and decoders.ġ. There are two standard approaches to performance measurements of JPEG2000 codecs, which utilize GPU. Approaches for JPEG2000 performance measurements Some of them are CPU-only, while the others use GPU to accelerate JPEG2000 computations. Here we present a comparison for available open source and proprietary J2K encoding software. Benchmarks for JPEG2000 encoders on CPU and GPUīenchmarks JPEG2000 Encoders are important to see the difference between CPU-based and GPU-based codecs. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |